Operation Manual

Alarm Switch :

The Administrator can enable or disable the alarm function.

Alarm Type :

Select an alarm type, “Normal close” or “Normal open”, that corresponds with the alarm application.

Alarm Output :

Define alarm output signal as “high” or “low” for the normal alarm output status according to the current alarm

application.

Triggered Action (Multi-option) :

The Administrator can specify alarm actions that will take place when motion is detected. All options are listed as

follows:

- Enable Alarm Output:

Select the item to enable alarm relay output.

- Send Alarm Message by FTP/E-Mail:

The Administrator can choose to send an alarm message by FTP and/or by E-Mail when a motion is detected.

- Upload Image by FTP:

Select this item, and the Administrator can assign a FTP site and configure various parameters as shown in the

figure below. When the alarm is triggered, event images will be uploaded to the appointed FTP site.

English