Use and Care Manual
Table Of Contents
- English (GB)
- 1. General information
- 2. Safety information for working on the product
- 3. Maintenance
- 4. Dismantling the product
- 4.1 Before dismantling the product
- 4.2 Removing the pump cover
- 4.3 Removing the pressure switch
- 4.4 Removing the connection module housing
- 4.5 Removing the membrane
- 4.6 Removing the chamber stack
- 4.7 Removing the shaft seal
- 4.8 Removing the control box cover
- 4.9 Removing the printed circuit board cover inside the control box
- 4.10 Removing the printed circuit board from the control box
- 4.11 Replacing the printed circuit board
- 4.12 Removing the capacitor from the control box
- 4.13 Removing the motor
- 4.14 Removing the motor stool and the flange
- 5. Assembling the product
- 5.1 Fitting the motor stool and the flange
- 5.2 Fitting the motor
- 5.3 Fitting the shaft seal
- 5.4 Assembling the chamber stack
- 5.5 Fitting the chamber stack
- 5.6 Connecting the capacitor to the printed circuit board
- 5.7 Fitting the printed circuit board
- 5.8 Fitting the membrane
- 5.9 Fitting the cover for hydraulic
- 5.10 Fitting the pressure switch
- 5.11 Fitting the pump cover
- 6. Additional information
