Install Instructions
Table Of Contents
- English (US)
- 1. Limited warranty
- 2. General information
- 3. Receiving the product
- 4. Installing the product
- 5. Starting up the product
- 6. Product introduction
- 7. Control functions
- 8. Servicing the product
- 9. Fault finding the product
- 10. Technical data
- 11. Disposing of the product
Status Explanation
Flashing red
(5 seconds)
during
installation
The LED flashes red for 5
seconds when pairing between
the temperature sensor and the
pump has failed. Restart of the
installation procedure is
recommended.
7.3 Push-button LED
LED status Explanation
Flashing blue
The LED flashes blue when the
push-button is ready for pairing
with the pump.
Blue
The LED lights blue for 5
seconds when pairing between
the push-button and the pump
has succeeded.
Flashing red
(5 seconds)
during
installation
The LED flashes red for 5
seconds when pairing between
the push-button and the pump
has failed. Restart of the
installation procedure is
recommended.
Flashing red
(2 seconds)
during normal
operation
The LED flashes red for 2
seconds when the battery level
in the push-button is at a
critical level, and the push-
button is activated.
Replacement of the batteries in
the push-button is
recommended.
Green
The LED lights green for 2
seconds when the push-button
is activated during normal
operation.
7.4 Repeater LED
The LED on the repeater will light green when the
repeater is in operation.
15
English (US)