Brochure
Table Of Contents
- 1. Product description
- 2. Type key
- 3. Product range
- 4. Operating conditions
- 5. Construction
- 6. Installation
- 7. Accessories
- 8. Curve conditions
- 9. Performance curves
- 10. Product numbers
- 11. Further product information
Curve conditions
MAGNA3
8
32
8. Curve conditions
Performance curves
The guidelines below apply to the performance curves
on pages X to X:
• Test liquid: airless water.
• The curves apply to a density of ρ = 61.38 lb/ft
3
[983.2 kg/m
3
] and a liquid temperature of 140 °F
[+60 °C].
• All curves show average values and should not be
used as guarantee curves. If a specific minimum
performance is required, individual measurements
must be made.
• The curves apply to a kinematic viscosity of
υ = 0.474 mm
2
/s (0.474 cSt).
• Reference supply voltage: 1 x 230 V, 50 Hz.
• EEI obtained according to EN 16297.
Note: Within the MAGNA3 performance range, the
constant- and proportional-pressure curves can be set
in steps of 0.1 m head on the control panel or with the
Grundfos GO Remote.
Symbols used on the following pages
Fig. 49 Energy efficiency index (EEI)
The MAGNA3 is energy-optimized and complies with
the EuP Directive (Commission Regulation (EC) No
641/2009) which will be effective as from 1 January
2013.
For MAGNA3 pumps, the average energy efficiency
index (EEI) is 0.18 with values down to 0.17,
categorised as best in class.
Fig. 50 Old energy label
From 1 January 2013, the old A to G energy label will
be replaced by the new energy efficiency index (EEI).
Only the best of today’s A-labelled circulator pumps
will meet the new requirements.
The MAGNA3 with its AUTO
ADAPT
function is the
preferred choice for large heating systems and a true
efficiency frontrunner.
Figure 51 shows the energy consumption index for a
typical circulator pump compared to the various EEI
limits.
Fig. 51 Energy consumption index
With an energy efficiency index (EEI) well below the
EuP benchmark level. With AUTOADAPT the
savings can be as much as 85%,
compared to a
typical circulator pump and thus a remarkably fast
return on investment. This means, of course, that the
MAGNA3 more than meets the standards of the EuP
legislation.
TM05 2682 0412
BEST
in class
BEST
in class
TM05 3936 1712TM05 3935 1712
Index
10
0
20
30
40
50
80
60
90
70
100
Typical
circulator
pump
EuP
2013
EuP
2015
EuP
benchmark
level
MAGNA3
labelled
labelled
EEI = 0.27
EEI = 0.23
EEI = 0.20
EEI = 0.17
Typical
circulator
pump
EuP
2013
EuP
2015
EuP
benchmark
level
MAGNA3