User Guide

45
English (US)
9.6 "Settings" menu
Navigation
"Home" > "Settings"
Press and go to the "Settings" menu with .
This menu offers the following options:
• Setpoint
• Operating mode
• Control mode
• Controller settings, not model A
•FLOWLIMIT
• Automatic Night Setback
• Analog Input
• Relay outputs
• Setpoint influence
• Bus communication
• General settings.
Navigate between the submenus with or .
9.6.1 "Setpoint"
Navigation
"Home" > "Settings" > "Setpoint"
Setting
1. Press [OK].
2. Select digit with and and adjust with or .
3. Press [OK] to save.
You can set the setpoint with an accuracy of 0.1 metre. The head
against a closed valve is the setpoint.
Set the setpoint so that it matches the system. A too high setting
may result in noise in the system whereas a too low setting may
result in insufficient heating or cooling in the system.
9.6.2 "Operating mode"
Navigation
"Home" > "Settings" > "Operating mode"
This menu offers the following options:
•Normal
•Stop
•Min.
•Max.
Setting
1. Select operating mode with or .
2. Press [OK] to save.
For detailed information about the operating modes, see section
8.2 Operating modes.
3.1.0.0.0.0 Settings3.1.1.0.0.0 - Settings_Setpoint_PropPress
Control mode Measuring unit
Proportional pressure m, ft
Constant pressure m, ft
Constant temperature °C, °F, K
Constant curve %
3.1.2.0.0.0 Operating mode