Install Instructions

5
English (US)
3.4 Identification
3.4.1 Type key
4. Operating conditions
Example J P 1 2 - 5 A - W - A - P - B V B P B - C - A PS
Type range (JP Self Priming)
Flow @ 10 m head [m
3
/h] Shaft seal
Maximum head [m] @ closed valve
Pump version
A: Basic version
D: Deep well
Pipe connection
W: Internal thread G
S: Internal NPT thread
Materials in contact with pumped media Pressure switch
A: Pump sleeve Cast iron
Pump shaft Stainless steel (DIN W.Nr 1.4005 / AISI 416) Mains plug
Stainless steel (DIN W.Nr 1.4305 / AISI 303) A: Prepared for cable glands*
Impeller/diffusor Composite (PPO 20% GF / noryl GFN2V) C: With cable
I: Pump sleeve Stainless steel (DIN W.Nr 1.4301 / AISI 304) D: Cable gland included
Pump shaft Stainless steel (DIN W.Nr 1.4305 / AISI 303)
Impeller/diffusor Composite (PPO 20% GF / noryl GFN2V) Motor information
C: Pump sleeve Composite (PP, 30% GF) C: IP44
Pump shaft Stainless steel (DIN W.Nr 1.4305 / AISI 303)
Impeller/diffusor Composite (PPO 20% GF / noryl GFN2V) Supply voltage
Gaskets / sealings (Excl. neck ring and shaft seal) A: 1 x 230 V, 60 Hz*
P: NBR (Acrylonitrile-butadiene-rubber) B: 1 x 115 / 230 V, 60 Hz*
Superior Grundfos type designation C: 1 x 220 / 240 V, 50 Hz
B: Rubber bellows seal
C: Unbalanced O-ring seal with spring as torque transmission element
Material rotating seal face
B: Carbon, synthetic resin-impregnated *Standard
V: Aluminum oxide (AI203) Voltage depending on pump size
Material stationary seal face
B: Carbon, synthetic resin-impregnated
V: Aluminum oxide (AI203)
Material secondary seal
P: NBR (Acrylonitrile-butadiene-rubber)
Max. operating pressure:
116 psi
(8 bar)
Liquid temp range:
+32 °F to +95 °F
(0 °C to +35 °C)
Max. relative humidity of air 95%
Storage temp range:
+14 °F to +104 °F
(-10 °C to 40 °C)
JP_JP-PS_US.book Page 5 Tuesday, July 19, 2011 8:07 PM