Installation Instructions

The timer is a 24-hour AM/PM timer with 20-minute inter-

val. For ease of programming the timer head can be swiveled

stop to stop almost 360 degrees.

TToo pprrooggrraamm tthhee ttiimmeerr::

11..

Using a small flatblade screwdriver remove the clear plas-

tic cover from the timer.

22..

The time of day is set by turning the programming ring in

the direction of the arrow (clockwise) until the correct time

is aligned to the arrowhead beneath the clock

symbol.

33..

Set the required "ON/OFF" times on the programming ring

by pushing the programming tabs either away from or

toward the center of the ring. Each tab represents a 20-

minute time interval. Tabs pushed toward the center turn

the circulator OFF and tabs pushed away from the center

turn the circulator ON.

44..

The timer function may be controlled using the OFF -

TIMER - ON switch. Setting the switch to OFF switches the

circulator off but does not affect the timer clock

operation. The green LED will be off. Setting the switch to

TIMER allows the circulator to Start/Stop according to the

programming tabs. The green LED will be on or off according

to the position of the programming tabs. Setting the switch

to ON provides continuous circulator operation. The green

LED is on.

55..

In case of power outage the timer will not keep time. After

power is restored the correct time of day must be reset.

66..

After setting the timer re-install the clear plastic cover.

COMFORT PUMP