TPE40-240/2 Products Guide
Table Of Contents
- Table of contents
- 1. Pump data
- 2. Performance range
- 3. Product range
- 4. Speed regulation
- 5. Operating condition
- 6. Pumped liquids
- 7. TP, TPE pumps
- 8. TPE Series 2000 pumps
- 9. TPE Series 1000 pumps
- 10. Communication
- 11. Motors
- 12. Curve charts
- 13. Installation
- 14. Accessories
- 15. Further documentation
- 16. Submittal data sheet
Communication
TPE E-circulators
10
20
10. Communication
Communication with TPE pumps
Communication with TPE pumps is possible via a
central building management system, remote control
(Grundfos R100) or a control panel.
Central building management system
The operator can communicate with a TPE pump even
when he is not present near the pump.
Communication can take place via a central building
management system allowing the operator to monitor
and change control modes and setpoint settings.
Fig. 7 Structure of a central building management system
Remote control
The R100 remote control produced by Grundfos is
available as an accessory.
The operator communicates with the TPE pump by
pointing the IR-signal transmitter at the control panel of
the TPE pump terminal box.
Fig. 8 R100 remote control
The operator can monitor and change control modes
and settings of the TPE pump via the R100 display.
Control panel
The operator can change the setpoint settings manu-
ally on the control panel of the TPE pump terminal box.
Fig. 9 Control panel of a TPE pump
TM02 6592 1103
LON-bus connection
G10-LON
Interface
GENIbus connection
TPE pump
TM02 0936 0501
TM00 7600 0304