Submittal Sheet

QUANTITY TAG NO. MODEL NO. GPM FEET VOLT PHASE COMMENTS
JOB or CUSTOMER:
ENGINEER:
CONTRACTOR:
SUBMITTED BY: DATE:
APPROVED BY: DATE:
ORDER NO: DATE:
SPECIFICATION REF:
60 Hertz
Technical Data
Series UP
Wet-rotor, End Suction, Maintenance-Free Circulator Pumps
FLOW RANGE: 0 to 16 U.S. GPM
HEAD RANGE: 0 to 12 Feet
MOTOR: 2 Pole, Single Phase
MIN. FLUID TEMP.: 50°F (10°C)
MAX. FLUID TEMP.: 140°F (60°C)
MAX. WORKING PRESSURE: 120 PSI
MIN. REQUIRED INLET PRESSURE:
Temperature: 140°F(60°C)
Pressure: 3 ft. (.9m) 1.3 psi
Spa PUMP
STAINLESS STEEL: Inlet cone, bearing plate and bearing
retainers, rotor can, rotor cladding, and shaft retainer.
ALUMINUM: Stator housing.
ALUMINUM OXIDE CERAMIC: Shaft and upper and lower radial
bearings.
METAL IMPREGNATED CARBON: Thrust bearing.
EP (Ethylene Propylene Rubber): O-ring and gaskets.
PP: Pump housing.
PES COMPOSITE, 30% Glass Filled: Impeller (UP15).
Noryl
®
: Terminal box.
Materials of Construction
Model Volts Amps Watts HP Capacitor
UP15-38SPA 115 0.74 85 1/25 10.0mF
230 0.40 90 1/25 2.0mF
Electrical Data
Applications
• SPA HEATING AND CIRCULATION • SPA OZONATION
• For indoor or protected outdoor uses
• Circulate chlorinated or brominated (clean/clear) water
with neutral pH
• Chlorine concentration (maximum): 5 ppm continuous,
10 ppm intermittent
• Bromine concentration (maximum): 3 ppm continuous,
5 ppm intermittent
• Ozone production and injection systems
NOTE: Do not introduce ozone to pump suction, as
air locking may occur
Features
• PP pump housing • End suction design
• Impedance protected motor
• External Aluminum Grounding Lug suitable for 6/14 AWG wire size
• Easy Drain Option
• Suction and discharge suitable for plastic tubing slip fit
• Internal 1/2" (ASTM plastic pipe fitting standards) 1" plastic barbed fitting
• UL/CSA approved and recognized to the spa and pool code
• 24/30 month standard warranty
• Maintenance-free design
Grundfos Submittal Data
UP15-38SPA