Install Instructions

Page 2
1.
Shipment Inspection
Check the contents of this package. Care should be
taken to ensure the pump is NOT dropped or mishan-
dled; dropping will damage the pump.
Grundfos Variable Speed Pump Package Includes:
• One Grundfos UP15-42 or UP26 Variable Speed
pump with integral control.
• One 6’ line cord with 115V plug, pre-wired into
control box.
• Two flange gaskets
• Installation and Operating Instructions.
2.
General Features
• All minimum and maximum settings are operating,
not safety limits. Necessary auxiliary equipment
and safety devices must be added.
• Offset dial provides fine tuning for input signal.
• Manual % dial provides manual speed control.
• Range of signal is selected through Dip Switch A
• Type of signal used is selected through Dip
Switch B
• Minimum speed at 0 or 15% is selected through
Dip Switch C
• Speed control from external signal or manual %
dial is selected through Dip Switch D.
• Pump Exercising: After every three days of no
operation, the control will exercise the pump for
10 seconds. The % Out LED will be on during
exercising
• As variable speed output modulates, the control
flashes the % out LED ON for ¼ second and OFF
for ¼ to 2 1/2 seconds
• The % output is run at 100% for 3 seconds after
power up reset for all modes of operation