Installation and Operating Instructions

7. Starting up the product
7.1 Connecting the unit to Grundfos GO
Remote 2.0
Before connecting the product, the Grundfos GO
Remote 2.0 app must be downloaded to your
smartphone or tablet. The app is free of charge and
available for iOS and Android devices.
CAUTION
Radiation
Minor or moderate personal injury
‐ Human tissue may be heated by RF
energy. Locate the antenna at a
minimum distance of 20 cm (7.87
inches) from any body parts.
1. Open Grundfos GO Remote 2.0 on your device.
Make sure that Bluetooth is enabled.
Your device must be within reach of the product
to establish Bluetooth connection.
2. Press the connect icon in Grundfos GO Remote
2.0.
3. Press the connect button on the product. The
blue LED is flashing until your device is
connected. Once the connection is established,
the LED is permanently on.
Grundfos GO Remote 2.0 is now loading the
data for the product.
4. Refer to the GiM quick guide for further
information regarding startup.
QR99802939
net.grundfos.com/qr/i/99802939
8. Servicing the product
The product cannot be serviced.
• Contact Grundfos. If the product is faulty, it must
be replaced.
8.1
Cleaning the product
The product must only be cleaned with a clean dry
or a soapy damp cloth.
9. Technical data
Electrical supply
Transient overvoltage Category II
Supply voltage
24-240 VAC/VDC, ± 10
%
Frequency DC, 50/60 Hz
Max. power consumption 11 W
Cables
Power supply cable
IEC: 0.75 - 4 mm
2
UL: 18 - 12 AWG
Use a 3-core cable that
meets the requirements
of the National Electric
Code.
Use copper or copper-
clad aluminum
conductors only.
Use a power cable with
an outer diameter of ø6 -
10 mm only.
Recommended
communication cable
Screened, double
twisted-pair
Cross-section: 0.2 - 0.3
mm
2
AWG: 24 - 22
Maximum cable length:
1200 m (4000 ft)
Use a communication
cable with an outer
diameter of ø4 - 10 mm.
Cable entry
5 x M16 ø3.5 - 10 mm
clamping range
13
English (GB)