Installation Guide

TECHNIQUES
TECHNIQUES
14 15
Using the 1/4” Leg
Use the 1/4” Leg (5) against the fence for
cutting width (Inside Cut) of 1/4” to 5/8”.
Note the location of the Handle (1) above
the cut line in order to apply balanced
pressure to both sides of the stock.
Irregularly Shaped Stock
This is a translucent bottom view with the
table saw top removed for clarity. The
GRR-RIPPER GR-200 is feeding irregularly
shaped stock to obtain a straight
edge. Notice the 1/2” Leg (5) does not
cover the stock edge completely. The
Adjustable Spacer (8) is used with the
smooth side down and leveled with table
top to prevent the tool from tipping over
and to glide against the rip fence for a
parallel feed. Watch the online video:
http://bit.ly/straight-line-ripping
WARNING! Before turning on the saw, always visually check the Saw
Blade Tunnel to make sure this is enough clearance for the saw blade to pass
through safely.
NOTE: All table saw illustrations in this instruction manual show a 1/8” kerf saw
blade and a rip fence that is secured parallel and to the right of the saw blade.
Inside Cut = Cut between rip fence and the saw blade, is usually the keeper piece.
Outside Cut = Cut on the left side of saw blade, is usually the off-cut piece.
Outside Cut Inside Cut
Rip fence parallel
to the saw blade
Always keep the
GRR-RIPPER in full
contact against
the rip fence
1/4” Leg
Saw Blade
5
Using the 1/2” Leg
Use the 1/2” Leg (4) against the fence
for cutting width (Inside Cut) of 5/8” to 3
3/16”. Use the Balance Support (6) when
stock is not wide enough to be under
the Side Leg on the left. The Handle (1)
is secured more towards the right side of
saw blade since no pressure is required
on the left side of the cut.
Balance Support Spacer
Using the Balance Support (6) against
the fence will provide an additional
2” of cutting width. The Adjustable
Spacer (8) can be used on the left as a
balancing device.
Outside Cut Inside Cut
Balance
Support
1/2” Leg
4
6
1
Rip Fence
Skew Handle (1) to exert
“auto” pressure against
the fence when pushed.
Balance
Support
6
8
Adjustable
Spacer
Add a wooden spacer for thicker
stock - use #8 pan head wood
screws & washers (not included).
5
8
14
15
16
17
Irregularly Shaped Stock