Installation Guide

ASSEMBLY
ASSEMBLY
10 11
COMPLETED GR-100
STEP 5
Brass Inserts
Balance Support
6
Attach Thumb Screws (E) to Balance
Support (6). Assemble Balance Support (6)
to either Basic Model GR-100 completed
Side Leg (4) or (5).
IMPORTANT: To keep the
non-slip pads working most
effectively, clean the contact
surfaces with denatured alcohol
or household rubbing alcohol and
a shop rag, prior to use. Repeat
cleaning during use as necessary
when saw dust accumulates. Do
not use if Green GRR-RIP is not
effectively gripping the workpiece.
Please contact MICROJIG in
regards to product issues.
E
x2
A
x2
C
x2
9
STEP 6
ASSEMBLY – GRR-RIPPER
ADVANCED MODEL GR-200
(GR-100+GRAK-404)
Assembly video available online at
http://bit.ly/grr-ripper-assembly
With hardware installed, snap the
Stabilizing Plate (7) into the open slots of
the Balance Support (6). It is by design
that the open slots are narrower than
the Shoulder Washer (P), so that the
Stabilizing Plate (7) will remain in place
during adjustments. The Stabilizing Plate
(7) can also be used with its straight edge
facing the GRR-RIPPER. IMPORTANT:
Push the Orange O-Ring (D) through
the T-Bolt (M) all the way down, making
contact with the Stabilizing Plate (7)
before inserting the Shoulder Washer (P)
and the Thumb Knob (N).
7
6
On top of slot
N
x2
P
x2
Orange
D
x2
M
x2
D
P
Reversible
11
The Adjustable Spacer (8) can be attached
to either Side Leg on the right or the
left. It can be used with the non-slip pad
downward to provide an additional gripping
surface pressure. Lower it to achieve two
levels of pushing surfaces. It can also
perform as a “balancing device” with the
non-slip pad facing upward.
STEP 7
COMPLETED GR-200
8
Brass Insert
Adjustable
Spacer
C
x2
Black
A
x2
E
x2
Reversible
12
13
10