Installation Guide

SAFETY BASICS
8
• The saw blade must not be set more
than 3/4” higher than the top surface
of a flat workpiece. The ideal height is
when the top gullet is slightly above the
top surface of the workpiece.
• It is the sole responsibility of purchaser
of this product to ensure that any third
party reads and agrees to all safety
precautions and terms prior to their use
of this tool.
• Do not use this product while under
the influence of drugs, alcohol or any
medication.
• To clean this product, use denatured
(available at the paint department of
home improvement centers or rubbing
alcohol (available at drug stores).
• When cutting small stock or irregular-
shaped workpieces, please ensure the
Balance Support and Adjustable Spacer
are securely supporting the GRR-RIPPER
to prevent any type of tilting. See Figure
16. If the GRR-RIPPER does not appear
stable or the user is not confident in
making the cut, do not proceed.
IMPORTANT: Never wear loose clothing,
gloves, bracelets or other jewelry that
may get caught in the moving parts or
cutting elements.
TABLE SAW PREPARARTION
• You must have a sturdy and straight rip
fence with a flat front surface preferably
at least 3” in height and square to the
table saw top. The rip fence must be
long enough to cover the entire depth
from the front to the rear of your table
saw top. The rip fence must also be
equipped with a locking mechanism to
secure it on the table saw top so that it
is parallel to the saw blade at all scale
settings. DO NOT SKEW THE
RIP FENCE!
• The rip fence should also be accurately
calibrated to a fixed scale to secure a
precise cutting width setting.
• A sharp and clean carbide-tipped saw
blade should be used with this tool for
ripping, unless otherwise specified.
• A Zero-Clearance Throat Plate or insert
(ZCI) should always be used when
cutting narrow strips. Watch our online
video on how to install a Zero-Clearance
Throat Plate: http://bit.ly/install-zci
Brass Inserts
L
x4
C
x4
Side Legs
54
&
ASSEMBLY
9
ASSEMBLY – GRR-RIPPER BASIC MODEL GR-100
Assembly video available online at http://bit.ly/grr-ripper-assembly
NOTE: If you purchased a GRR-RIPPER HANDLE BRIDGE KIT (GRHB-010), please refer
to its instruction manual for installation and resume GRR-RIPPER assembly at Step 2.
Install both Side Legs (4) and (5) in the
same manner to opposite sides of the
Main Body (2). Insert the screws and
washers through the front screw holes,
insert the O-Rings from the back side.
See Figure 8 for detail. IMPORTANT:
If you purchased the GR-200, do not
confuse the Black smaller O-Ring (C)
and the Orange larger O-Ring (D).
STEP 3 & 4
Handle
1
Main Body
2
3
2
1
G
B
G
x2
K
x2
x2
Assemble Handle (1) to the top slots of
Main Body (2).
STEP 1
Attach mounting hardware to Center Leg
(3). Assemble Center Leg (3) to the end
slots of Main Body (2) (see Figure 6A).
STEP 2
Close-up view with
Handle and Center Leg
installed on Main Body
Close-up of O-Ring
embedded in
counter-bore
Main Body
2
3
Center Leg
A
x2
F
x2
x2
H
H
5 7
6
6A 8