Installation Guide

WARNING! The GRR-RIPPER 3D PUSHBLOCK system is capable to control
stock narrower or shorter than the GRR-RIPPER on your woodworking machines,
user must make sure that the Balance Support and the Adjustable Spacer are
properly adjusted to keep the GRR-RIPPER balanced on the stock so it will not tip in
any direction, example shown in Fig 16 on page 15.
User must pay attention to the gripping effectiveness of the Green Non-Slip pads
before every use, do not use the GRR-RIPPER if you feel it is not gripping the stock,
clean with denatured/rubbing alcohol or replace the leg(s) with new Green GRR-RIP
®
non-slip pads, if necessary.
NOTE: Parts listing page folds out for
your convenience. Reference this page
during assembly.
GRR-RIPPER PARTS GR-100 GR-200
1 Handle 1 1
2 Main Body 1 1
3 Center Leg 1 1
4 1/2” Side Leg 1 1
5 1/4” Side Leg 1 1
6 Balance Support 1 1
7 Stabilizing Plate 1
8 Adjustable Spacer 1
HARDWARE Red Bag Blue Bag
A #10 x 7/16” OD Washer 8 8 2
B 1/4 x 1/2” OD Washer 2 2
C 9/32” OD O-Ring (#10 screw) Black 6 6 2
D 5/16” OD O-Ring (1/4-20 screw) Orange 2
E 10-32 x 1/2” Thumb Screw 2 2 2
F 10-32 x 5/8” Thumb Screw 2 2
G 1/4-20 Oval Nut 2 2
H 10-32 Offset Oval Nut 2 2
K 1/4-20 x 3/4” Pan Head Screw 2 2
L 10-32 x 1/2” Pan Head Screw 4 4
M 1/4-20 x 1 3/4” T-Bolt 2
N 1/4-20 Thumb Knob 2
P Nylon Shoulder Washer 2
GR-100 GR-200
NOTE: Please check if you have all the parts
and hardware before assembling.
GRR-RIPPER models are available in black or yellow.
Part colors may vary depending on model purchased.
If you have purchased the GRR-RIPPER
Upgrade Kit (GRAK-404) please reference
Step 6 on Page 10 for installation instructions.
4
7
2
8
4
3
5
6
1
TAPERING JIG
For use on table saws with the
GRR-RIPPER ADVANCED MODEL GR-200
CUTTING-EDGE TAPERS
The PRECISION, SAFETY and CONTROL of the MICRODIAL™
Tapering Jig advances your woodworking with ease. Combine
the MICRODIAL™ Tapering Jig with 1 or 2 GRR-RIPPER
ADVANCED GR-200s to craft impeccably tapered legs.
Achieve precise angles with the MICRODIAL™ while safely
powering through each cut with the GRR-RIPPER.
VERSATILE TAPERED LEGS
• Create 2-, 4-, 6- or 8-sided
tapered legs
• Use on the router table
to create custom tapered
profiles for exquisite
detail on your project legs.
WORK WITH PRECISION
The interlocking
COLORMATCH™ system
ensures the angle of your
taper to 1/8th of a degree
(incrementally up to10
degrees).
WORK FASTER Switch quickly and easily
between two tapers on a single workpiece.
MEMORYLOCK™ maintains two independent
stops for you.