Owner's Manual
1
3
2
4
Unscrew sediment and carbon
lter housings using supplied
lter wrench. Wash inside of lter
housings to remove debris.
Tighten lter housings by hand,
do not use lter wrench. Do not
over tighten.
Install new sediment and carbon
lter, making sure they go into
the correct lter housings.
Clean o’ring and o’ring seat, then
re-grease with food grade silicon
grease.
Sediment
Carbon
O-ring
6
Pre-lters should be changed when either brown discoloration occurs,
or system ow rates have signicantly declined.
Always turn incoming water pressure o before servicing the unit.
Always turn incoming water pressure on slowly, allowing all air to be
discharged before full water pressure is restored.
REPLACING PRE-FILTERS