Owner's Manual

Insert stem elbow ttings. Make
sure they are completely seated.
Mount UV with supplied clips to
the RO lter.
Attach the electrical connections to
both ends of the bulb. Make sure
bulb is clean of grease and oil.
Make sure housing collar is rmly
tightened. Do not over tighten as this
will cause glass inner sleeve to break.
Insert bulb and wiring into sleeve. Seat rubber boot over the collar.
1
3
5
2
4
6
3
Built in the U.S.A.
CONNECT WATER LINES, START THE SYSTEM AND CHECK FOR LEAKS.
IF NO LEAKS EXIST, PLUG IN THE UV FILTER AND ENJOY!
• First remove lamp from packaging.Try not to touch the bulb with your hands.
The oils may cause hot spots on the bulb and early failure.
• Bulbs should be replaced yearly.
UV-1530 SETUP INSTRUCTIONS