Owner's Manual
Part #
PLUMBING
In / Out
Voltage Amps Flow Rate
High Pressure
Cuto
Duty Cycle
DDP-4-VARI
1/2”
quick connect
120 VAC 1.6 1-4 GPM Yes Intermittent
INSERT TUBE INTO FITTING
Push the tubing through the collet and dual o-rings until it bottoms
out against the tube stop.
The collet holds the tube in place and the dual o-rings provide a
leak resistant seal.
MAKE A CLEAN TUBE CUT
Cut the tube squarely and if using plastic tubing, ensure that the cut
has not made the tube out of round.
Also ensure that the tube has a smooth outside diameter without any
burrs or score marks prior to inserting it into the tting.
TEST AND INSPECT
Push and pull the tubing toward and away from the tting to ensure
that it has been installed properly.
Test and inspect the installation for any leaks.
TUBE REMOVAL
Relieve pressure from the tubing and tting.
Push uniformly around the collet ange against the tting body while
pulling the tubing away from the tting to release it.
O-RING
COLLET
TUBING
PUSH COLLET IN
PULL TUBE OUT
GROWONIX WATER FILTERS USE QUICK CONNECT FITTINGS
THAT ALLOW FOR EASY MAINTENANCE.
• The DDP-4 Vari pump is designed for intermittent duty, but may run continuously if the motor
temperature does not exceed the recommended limit.
• DDP Series Pumps are equipped with thermally protected motors, and in case the motor
temperature exceeds the thermal cut-out rating, the pump will shut down, and will not restart until
motor cools down to specied temperature.
ELECTRICAL
SPECS
5
Built in the U.S.A.