DDP-20 ELECTRONICALLY CONTROLLED WATER DELIVERY PUMP w w w. g r o w on i x . c o m Built in the U.S.A. www.growonix.com toll free 888.406.8521, office 818.510.0264, sales@growonix.
INTRODUCTION OUR MISSION Durability, Reliability, Efficiency, Purity, and Conservation form the foundation on which we design and build all of our products. Consistent and superior quality sets us apart from other manufacturers and increases our value to you - our customer. Whether you are a hydroponics hobbyist, serious enthusiast, or large-scale gardener, GrowoniX is committed to bringing you the best solution for water purification systems.
FEATURES 20 GPM Water Flow Rate Stack Multiples for Added Flow Rate Auto Shut-Off Circuitry under 0.7GPM.. High Pressure Cutoff Ultra Quiet and Compact Perfect for Big Water Transfer & Whole House Duty Perfect Booster for CX Series 9,000 GPD and under Constant Duty WHY USE A GROWONIX DDP-20? • To raise the water pressure on a water filtration system. • To transfer water from tank to tank. • To raise the pressure on any water appliance that flows from between 1-20 GPM @ 55psi.
INSTRUCTIONS TQ Series Manual Please read all Instruction instructions carefully before installing your new DDP-20, as failures caused by installation or operation are not covered bysystems, the warranty. Please readincorrect all instructions carefully before installing your new as failures caused by incorrect installation or operation are not covered by the warranty. I. PRODUCT I.
IV. Piping 1. The suction line should be installed as short and straight as possible, with a minimum of bends. IV. PIPING The internal diameter of the suction pipe must be equal to, or greater than the ports of the 1. The suction line should be installed as short and straight as possible, with a minimum of bends. pump. The internal diameter of the suction pipeline must bepump equalmust to, orbe greater than thethe ports of the pump. 2.
INSTRUCTIONS CONT. ly applied city pressure can exceed pump operating pressure and damage the p 2. Flooded Suction -from city water supply 2.
ELECTRICAL This mark located outside the connection box is a warning for an electrical hazard. 1. Ensure the mains voltage is the same as the value shown on the motor plate and that the pump is safely connected to ground/earth. 2. The single phase models are supplied with plug and lead and can be connected directly to the mains supply. The 3 phase models should hook up with a circuit breaker. WARNING Risk of electric shock - This pump has not been investigated for use in swimming pool or marine areas.
INSTRUCTIONS CONT. VII. CYCLING IX. Precautions 1. The pump should be shut-down and the trouble corrected if the pump is running at speed and found to have The pump should be shut down and the trouble corrected if the pump is running at speed and any of the following1.
FREQUENTLY ASKED QUESTIONS FREQUENTLY ASKED QUESTIONS 1. WHAT CAUSES THE DDP-20 TO START? The DDP-20 has the built-in pressure switch and internal flow switch. Each of these can turn the pump on depending on water consumption. The pump will start when: - The pressure is BELOW the pressure switch activation point. OR - The flow rate is greater than 0.7 GPM. 2. WHAT CAUSES THE DDP-20 TO STOP? The flow switch is designed to automatically stop the DDP-20 when flow drops to below 0.7 GPM.
SPECIFICATIONS DIMENSIONS (INCHES) DDP-20: (A)13.23” (B) 5.08” (C) 5.
GROWONIX SYSTEM WARRANTY For a period of one year from the date of original purchase, we will replace or repair any part of the GrowoniX product that we find to be defective in operation due to faulty materials or workmanship with the exception of the replaceable filters and membranes.
DDP-20 ELECTRONICALLY CONTROLLED WATER DELIVERY PUMP w w w. g r o w on i x . c o m Built in the U.S.A.
