Owner's Manual

WATER PUMP PRESSURE SWITCH
Turn clockwiseto increase
cut-out pressure, without
affecting cut-in.
PRESSURE SWITCH HAS ONLY TWO ADJUSTMENT TERMINALS
WATER PUMP PRESSURE SWITCH ADJUSTMENT
TURN
CLOCKWISE
TO INCREASE
-OUT
-IN
PRESSURE
MOTOR
LINE
LINE
POWER
SUPPLY
MOTOR
M
* *
THE PUMP MUST NEVER BE RUN DRY. OPERATING THE PUMP WITHOUT SUFFICIENT FEED
WATER WILL DAMAGE THE PUMP.
ALWAYS FEED THE PUMP FILTERED WATER. THE PUMP IS SUSCEPTIBLE TO DAMAGE FROM
SEDIMENT AND DEBRIS.
IF ANY DAMAGE OCCURS TO YOUR SYSYTEM’S PUMP, A RE-BUILD KIT MAY BE AVAILABLE.
CONTACT YOUR LOCAL DEALER OR DISTRIBUTOR AND INFORM THEM OF YOUR SYSTEM’S
MODEL AND PUMP SIZE.
• The pump is a low-lead brass rotary vane pump.
• This pump is also available in stainless steel.
• Follow these guidelines to ensure proper operation of the pump:
The low pressure switch shuts o the system when the feed water pressure drops too low for the
system to function properly. This prevents damage to the pump. The system restarts automatically
when the pressure is restored. If you notice the pressure uctuating, and the system cycling o and
on repeatedly, turn the system o and ensure that proper feed ow and pressure are available to the
system.
The water pump pressure switch is adjusted at the factory to cut out when incoming pressure falls
below 10 psi, and cut in when incoming pressure reaches 25 psi.
PRESSURE SWITCH SHOULD NOT NEED ADJUSTMENT.
If for some reason pressure switch should fall out of adjustment, follow the diagram above. Factory
settings are:
Terminal 1 adjusted fully counterclockwise.
Terminal 2 adjusted fully counterclockwise.
1 2
7
6
Built in the U.S.A.
Turn clockwise to increase
both cut-out and cut-in
pressure.
BP-6010 INFORMATION