Owner's Manual

4
• The BP-6010 series of Booster Pumps are designed for use with all GrowoniX EX1000 & GX1000
water lters.
• The pump is designed to boost low water pressure conditions to optimal pressure.
• Do not exceed 150 psi output pressure.
ABOUT
CAUTIONS
MOUNTING
• The pump is equipped with an adjustable bypass valve which controls the maximum operating
pressure. In addition, never subject the pump to pressures above 150 PSI.
• Never operate the pump in a harsh environment or hazardous atmosphere,
since motor brush and switch may cause electrical arcing.
• Pumphead materials are designed for use with water only. Do not use with petroleum products.
• Always consider electrical shock hazard when working with and handling electrical equipment.
If uncertain, consult an Electrician. Electrical wiring should only be done by a qualied Electrician
per Local and State Electrical Codes.
• The pump should be mounted in a dry place and away from any source of heat. If an enclosure is
used, special provisions for cooling the motor may be necessary. Consult the Factory.
• Do not subject the pump to extreme high or low (freezing) temperatures while in operation.
(Operating ambient temperature range is 32ºF to 115ºF).
• The pump may be mounted in the vertical or horizontal position.
READ ENTIRE MANUAL THOROUGHLY
BEFORE INSTALLING THIS HIGH PRESSURE-BOOSTING PUMP.
INSERT TUBE INTO FITTING
Push the tubing through the collet and dual o-rings until it bottoms
out against the tube stop.
The collet holds the tube in place and the dual o-rings provide a leak
resistant seal.
MAKE A CLEAN TUBE CUT
Cut the tube squarely and if using plastic tubing, ensure that the cut has
not made the tube out of round.
Also ensure that the tube has a smooth outside diameter without any
burrs or score marks prior to inserting it into the tting.
TEST AND INSPECT
Push and pull the tubing toward and away from the tting to ensure
that it has been installed properly.
Test and inspect the installation for any leaks.
TUBE REMOVAL
Relieve pressure from the tubing and tting. Push uniformly around
the collet ange against the tting body while pulling the tubing away
from the tting to release it.
O-RING
COLLET
TUBING
PUSH COLLET IN
PULL TUBE OUT
GROWONIX WATER FILTERS USE QUICK CONNECT FITTINGS
THAT ALLOW FOR EASY MAINTENANCE.
4
Built in the U.S.A.
BASIC INFORMATION