Owner's Manual

Slide the 1/2” locking clip o of
the carbon lter output tting, and
remove the short length of 1/2”
tubing feeding the membrane input.
1
Cut tubing to the appropriate length
(ensure no kinks or ow restrictions), and
insert into the 1/2” pump input. Install the
1/2” locking clip.
5
Insert the supplied 1/2” tubing into the
carbon lter output. Install the 1/2”
locking cip.
4
Insert the supplied 3/8” tubing into
pump high pressure output. Install the
3/8” locking cip.
6
3
Install the caster onto the chassis
bottom.
2
SETUP INSTRUCTIONS FOR BP-6010-CH
Attach BP-6010-CH chassis to
GX600/1000 housing using the
existing caster hardware.
10
Built in the U.S.A.
TURN OFF INCOMING WATER SUPPLY AND DRAIN SYSTEM PRESSURE BEFORE
INSTALLING A BP-6010 PUMP