Safety Instructions

EN
10 11
FILTER
This appliance is equipped with 3 types of lters:
Prefilter Active Carbon
filter
Particlefilter
NanoCaptur+
filter
Frequency of cleaning/replacing the lter :
Filter Action Cycles
3-in-1 pre-lter, allergy+ lter
and active carbon
Replace
Every 12 months or when the
lter change indicator is lighted
The recommended frequency for replacing the lter may vary depending on the duration of use
and the operating environment.
IMPORTANT:
The lter change indicator (6) is lighted when the lter needs to be replaced. Once the lter has
been replaced, hold down the button for 3 seconds.
Forced reset:
If you have replaced the lter before its end of life, force the reset of lter cycle:
1. Hold the lter change indicator (6) for 3 seconds.
2. The indicator is lighted. Hold down the button for 3 seconds, to reset the lter cycle.
« TIPS FOR CHANGING FILTERS »
• Avoid handling used lters if you suffer from allergies or asthma.
• Wear gloves when changing the lters, or wash your hands well afterwards.
• Put used lters directly into a closed, air-tight bag before throwing them away to
avoid spreading pollutants.
POLLUTION SENSOR
The particles sensor need to be cleaned regularly (every 2 months) and appropriately.
Make sure you turn off and unplug the appliance before cleaning the pollution sensors and follow
the recommendations below:
1. Clean the air inlet and outlet using a soft brush or cloth.
2. Open the sensor cover located on the right-hand side of the appliance.
3. Lightly wet a cotton swab and remove any dust from the lens and the inlet/outlet. Wipe using
a dry cotton swab.
4. Clean the sensor using a soft brush or vacuum cleaner.
5. Replace the sensor cover
543
2
1
IMPORTANT:
• Never use a detergent or metal object to clean the sensors.
• The efciency of the sensors may be reduced if not cleaned regularly.
• Cleaning frequency varies depending on the operating environment of the appliance. If it is
used in a dusty environment, clean the sensors more frequently.
STORAGE
When you are not using the appliance, store it in a cool, dry place with ambient conditions no
higher than 35°C 70%RH.
IN THE EVENT OF A PROBLEM
• Do not disassemble the appliance yourself. A poorly repaired appliance may be dangerous for the user.
• Check the troubleshooting table below before contacting an Approved Service Center:
Problem Check Solution
The appliance does not
switch on.
Is the power cord connected?
Connect the power cord to a plug with
the correct voltage.
Are all the display elements o?
Press the on/o button and select the
required function.
Is these a power outage?
You can use your purier once the
power turns on again.
The air ow does not
change automatically.
Is the appliance in manual
mode?
Select the correct operating mode.
The ow is a lot weaker
than before.
Does the lter need to be
cleaned or replaced?
Check the lter replacement
frequencies and replace the lter if
necessary.
There is an unpleasant
smell coming from the
air outlet.
Does the light still indicate poor
air quality?
Check the lter replacement
frequencies and replace the lter if
necessary.
The air quality indica-
tor does not change
color.
Is the sensor lens covered with
dust?
Clean the sensor lens with soft
brush.