DT430 Expansion Modules Quick Start Guide 1
Copyright Copyright2011 Group Sense Mobile-Tech Limited. All rights reserved. No part of this document may be reproduced, distributed, translated, or stored in any form without the prior written permission of Group Sense Mobile-Tech Limited. All brands and product names mentioned herein may be trademarks or registered trademarks of their respective owners. Product specifications are subject to change without prior notice. Disclaimer The contents of this document are provided as is.
Regulatory Information FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Laser Warning Statement Barcode scanner expansion module contains Class 2 type laser scan engine. The scanner and imager engine meet the accessible laser light limits for an CDRH/IEC Class 2 laser and IEC Class 1M LED product. The following applies to the scan engine. “Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated July 26, 2001.
Safety Information Please read the following information carefully before using the device for the first time, and keep this Quick Guide in a safe place for future reference. Do not stare directly into the laser beam, or direct the laser beam into eyes. Always treat the device with care and keep it in a clean and dust-free environment. Do not expose the device to extremely hot, cold or humid environment. Do not use the device in wet or rainy conditions.
DT430 Expansion Module Overview Module Model No. DT430 (1D) DT430 (2D) DT430 (RFID) Module Type 1D Barcode Scanner 2D Barcode Scanner RFID Reader Installing the Expansion Module To install the Expansion Module 1. Turn over the DT430 handheld terminal. 2. Remove the two screws on the DT430 back cover with a screw driver. 3. Remove the back cover from DT430. 4. Insert the Expansion Module into DT430 module slot, and slide the module until it fits tightly in the slot. 5.
Scanning Barcodes 1. Aim the barcode reader aperture of the handheld at the barcode. 2. Press Right Scan Key or Left Scan Key to scan the barcode. 3. If scanning is not able to complete and time-out, try adjusting the angle or distance between the handheld and the barcode; and press Right Scan Key or Left Scan Key to scan again.
Scanning RFID Tags 1. Hold the handheld with the RFID expansion module parallel to and directly above the RFID tag. The scanning distance should be kept 3cm at most. 2. Press Right Scan Key or Left Scan Key to scan the barcode. Correct RFID tag scanning Position handheld parallel to the tag. Keep scanning distance within 3cm. Incorrect RFID tag scanning Do not hold the handheld perpendicular to Do not position the handheld at an angle or the tag. too far from the tag.
Copyright 2011 Group Sense Mobile-Tech Limited, All rights reserved. http://www.gsml.com.
