30 Day Right To Return We do not envisage any problems occurring with your Groove-e GV-DRO8 Boston. However, for your peace of mind, should any fault occur, please rectum it within 30 days to your retailer with proof of purchase for an exchange or refund. 12 Month Guarantee This product is guaranteed for twelve months.
Conditioners on vol pusher ong Tina Bu for choosing Lhe Move OV LORE Boston, loonie DAE Diciest Radio with Billhook Please ron te ser guide coed boos iii. Important safety information 1+ Keep the product and all its parts out of reach of small children. 2+ Do NOT leave it in high temperatures as electronic devices and plastic parts may warp in heat. No naked flame sources, such as lighted candles, should be placed on the product.
OVERVIEW Alarm/. ‘ Si “Tuner booze speaker TC! Conrail b wheel ne Speaker Volume Telescopic Antenna re Fully extend the antenna on before you scan for DAB or FM stations * & ied Requires 4 x 15V {size batteries .
OPERATION Power On and Auto scan . 1. Connect the mains power lead into the DC5.9V socket on the back of the radio and fully extend the telescopic aerial in a vertical position to obtain the maximum signal strength, ) £2. Connect the power plug to the mains power socket and switch the power on, 3. Press the POWER button on the radio. Note: The radio will automatically begin to scan for DAB stations. The screen will show the progress, of the search.
oo OPERATION Adjusting the Volume Rotate the VOLUME control clockwise or anti-clockwise to increase or decrease the volume output. A slider bar will appear on the display screen to show the current volume level, Switching Modes 1. Press the MODE button on the product to switch to the available modes: DAB FM & BLUETOOTH, Check the display to confirm the modes. Bluetooth Mode 1. Repeatedly / press the MODE button until you are in BLUETOOTH mode.
OPERATION Using DAB for the First Time 1. After switching to DAB mode for the first time a full scan of DAB stations Is performed automatically. SS During full scan mode, o bar will be Son : : displayed, showing the progress of EBENEEZER CTE the scan and the number of radio br stations that have been found so far. When the scan is complete the radio will select the first available station, stations are listed in alphabetical order. Note: The station Nome will be shown on the top line of the display.
OPERATION Changing Stations (DAB) 1. Use the + Tune and Tune ablutions to scroll through the available stations. 2. When the station that you would like to listen to is displayed, press the SELECT button. There will be a short delay whilst your radio tunes to your selected station. Note: If no stations were found, or no DAB stations can be received currently [No DAB station] will be displayed. in this case you may need to perform another station scan.
OPERATION Prune stations (DAB) You can remove DAB stations in the station list that cannot be received in your area. They are listed with a 7’ prefix. 1. Press and hold the MENU/INFO button in DAB mode to enter the menu options. Use the 4 Tune and Tune Ww buttons to display . Press the SELECT button. £2. Use the «4 Tune and Tune buttons to scroll to Yes, Press the SELECT button to prune the station list.
OPERATION DAB Display Information Every time you press the MENU/INFO button the display will cycle through the following information options. « DLS (Dynamic label segment): Dynamic label segment is a scrolling message that Y the broadcaster may include with their THEE fire ling 1a9t transmissions. This message usually ¥ includes information, such as program detail filial Brethren etc, ¥ «= Signal strength: This option will display a Rag rammed bar indicating the signal strength.
OPERATION DRC {Dynamic Range Control) This causes the radio to change the dynamic range of the audio signal. Changing the dynamic range can change the loudness’ and/or ‘quality of sound of the programmer that you ore listening to so that it will be more suited to your listening environment. 1. Press and hold the MENU/INFO button in DAB mode to enter the menu options. Use the #4 Tune and Tune » buttons to display . Press the SELECT button. 2.
OPERATION Scan Setting (FM) When performing a scan you can set the sensitivity level of the stations to be found. Eg. strong signals only or olf stations. 1. In FM mode, press and hold the MENU/INFO button, will be displayed. Press the SELECT button. £2. Use the A Tune and Tune ® buttons to display (which will detect any station, even with o weak signal) or (which will only detect stations with a good signal strength). Press the SELECT button.
OPERATION Recalling a Preset (FM) 1. Press the PRESET button. is displayed together with the name or frequency of the station stored there, or (Empty) if no station has been stored there. 2. Use the «4 Tune and Tune W bunions to move to the Preset location and station that you would like to listen to 3. Press the SELECT button. The radio will tune to that station. FM Display Modes Every time you press the MENU/INFO button the display will cycle through the following information options.
OPERATION 2. Alarm 1 Setup is displayed. To set Alarm 2 press the ALARM/SNOOZE button again, Press the SELECT button. 3. Alarm 1 Wizard On time Is displayed and the hour digits for the alarm will flash. Use the 4 Tune and Bellybuttons to set the hour for the alarm and press the SELECT button, 4. The minutes for the alarm will now flash. Use the «4 Tune and Tune » buttons to set the minutes for the alarm and press the SELECT button. 5. The duration of the alarm will now flash.
OPERATION 10. A bell icon will appear in the top right of the display to confirm that an alarm has been set. Note: If the time is not set or has foiled to update from the radio signal, ‘Time is not set’ will be displayed when you try to set the alarm. The radio will then prompt you to set the time. An alarm can only be set after the time has been set. Stop the Alarm 1. When the alarm sounds, press any button except the ALARM/SNOOZE button to tum the alarm off. Alarm off will be displayed.
OPERATION 3. After a short delay, the Sleep time you have set will appear in the top right of the radio display eg $30 and will count down until your radio will automatically go to STANDBY mode. Note: To cancel the Sleep timer, follow the steps above and select Sleep off in Step 2. Display back light timeout You can adjust the back light timeout, Options 120, 180 seconds and timeout off are available. 1. Press and hold the MENU/INFO button. Use the «Tune and Tune ¥ buttons to display .
OPERATION Software Version 1. Press and hold the MENU/INFO button. Use the Tune and Tune buttons to display . Press the SELECT button. 2. Is displayed. Use the %€ Tune and Tune® buttons to display . Press the SELECT bunion. 3. The software version will be displayed. Factory Reset Note: If you reset your radio all of your stored station presets will be deleted and any connected Bluetooth devices will be unpaired. 1.
FEATURES = DAB/FM radio = Stereo Speakers « 40 preset stations: 20 DAB & 20 FM Bluetooth connectivity for wireless music playback « l Wooden cabinet with metal speaker mesh = Backbit LCD display * Radio text « Auto scan & manual tuning = {lock time ond date « Dual alarm wake up to radio or buzzer » Snooze function « Sleep timer = Display dimmer = Telescopic antenna * AC Mains power (included) «4 x { size batteries of included) DAB/FM Radio Bluetooth Stereo Alarm & or (40 Presets) Connectivity =~ Speakers Di
GUARANTEE Subject to the conditions stated below, Groove-e guarantees this equipment against defects in workmanship or materials of its mechanical and electronic component parts (excluding styling, battery cells, magnetic tapes, re-chargeable batteries, user removable memory devices, with the exception where the battery is inbuilt into the product) for a period of one year from the of purchase, This product will be ride or if necessary replaced free of charge if it has been proven to be defective in the one
This guarantee is in addition to and does not in any way affect any statutory or other right of consumer purchasers, including those rights in relation to sections the Sale of Goods Act 1979, the Sale and Supply of Goods to Consumer Regulations 2002, The Consumer Rights Act 2015 or the Sale of Goods and Supply of Services Act 1980 (for ROIL.
