Instructions / Assembly

WWW.gronomics.com East Bethel, MN USA

763-753-7374

Continued

Install six 1/4” x 2-1/2” screws (Item 6) into the pre-

drilled holes of the leg assembly.

Repeat procedure for the leg assembly at opposite

end.

Seat / Leg Assembly Continued

Remove the bench from the work table and place

the bench on the ground as shown.

Place the backrest spacers (Item 5) and backrest

surface panel board (Item 1) as shown. This will

allow a 1-3/8” gap between the backrest surface

panel boards.

NOTE: Make sure the backrest surface panel board

ends are flush with the ends of the seat surface

panel boards.

Install four 5/16” x 3-1/2” screws (Item 7) into the

pre-drilled holes and tighten.

Remove the backrest spacers.

Backrest Assembly