Instructions / Assembly

WWW.gronomics.com East Bethel, MN USA 763-753-7374

Continued

Place the seat spacers (Item 4) between the

inner surface panel board and center surface

panel board as shown. This will allow a 1/2” gap

between the boards.

NOTE: Make sure the center surface panel

board is snug to the seat spacers and that the

boards are flush at each end.

Install two 1/4” x 2-1/2” screws (Item 6) into the

pre-drilled holes of the leg assemblies at each

end and tighten.

Remove the seat spacers.

Seat / Leg Assembly Continued

Inner Board

Center Board

Place the seat spacers (Item 4) between the outer

surface panel board and center surface panel board.

NOTE: Make sure the outer surface panel board is

snug to the seat spacers and that the boards are

flush at each end.

Install two 1/4” x 2-1/2” screws (Item 6) into the pre-

drilled holes of the leg assemblies at each end and

tighten.

Remove the seat spacers.

Seat / Leg Assembly Continued

Outer Board