Instructions / Assembly

WWW.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Place the backrest spacers (Item 5) at the top of
the lower backrest board. Place the upper
backrest board (Item 1) onto the spacers.
NOTE: Make sure the top backrest surface panel
board ends are flush with the bottom backrest
surface panel board ends.
Install four 5/16” x 3-1/2” screws (Item 7) into the
pre-drilled holes and tighten.
Remove the backrest spacers.
Backrest Assembly Continued
8
1
7
5
5
Place the backrest top rail surface panel board (Item
1) as shown.
NOTE: Make sure the backrest top rail surface panel
board ends are flush with the backrest surface panel
board ends.
Install two 1/4” x 2-1/2” screws (Item 6) into the pre-
drilled holes and tighten.
Repeat procedure at the opposite end.
Backrest Top Rail Assembly
9
1
6