Instructions / Assembly

WWW.gronomics.com East Bethel, MN USA 763-753-7374
Remove the two post caps from the Garden Wedge.
NOTE: The extension kit can be assembled on ether
end of the Garden Wedge.
Install four 45” x 5-5/8” side rails (Item 2) into the upper
part of the slots between the two corner posts and slide
down.
Side Rail Assembly
3
2
2
Post Caps Removed
Install the four remaining 45” x 5-5/8” side rails (Item 2)
into the upper part of the slots between the two corner
posts and slide down.
Install the four end side rails (Item 6, 5, 4 & 3) into the
upper part of the slots between the two corner posts
and slide down.
Remove the rubber caps from the post studs. Install a
stiffener plate (Item 8) on the top end rail as shown.
NOTE: May need to lift boards 3,4,5 & 6 slightly by
placing fingertips under board 6 to get the stiffener
plate in place.
End Rail Assembly
4
2
8
4
5
6
3
Install the 43-3/8” x 2-1/2” bottom center rail (Item 7)
with the tapered edges of the rail facing down.
Install the fabric liner into the Garden Wedge.
Soil Capacity: 6.5 Cubic Feet
Bottom Center Rail Assembly
5
7
Align the hole of the 4” x 4” post cap (Item 9) with stud
and tighten until the post cap makes contact with the
post. Do not overtighten.
Post Cap Assembly
6
Stud
9
Proof 8-18-14