Tow Draw Bar Instruction Manual

ManualsBrandsGrizzly ManualsAutomobile AccessoriesTow Draw Bar G8731

MODEL G8731/G8732/

G8733

TOW DRAW BAR

INSTRUCTIONS



WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.



1. This tow draw bar was designed to

mount into a 2" x 2" square hitch

receiver. NEVER use this product for

any purpose it was not designed for.

2. Know your load and tongue weight!

NEVER exceed the gross load towing

capacity or the tongue weight capacity

of the hitch receiver or draw bar.

3. When mounting the draw bar, only use

an approved hitch pin with a safety clip

properly installed through the hitch

receiver and draw bar.

4. ALWAYS attach load-appropriate safe-

ty chains to the load and through the

hitch receiver chain loops.

5. ALWAYS thoroughly inspect each com-

ponent of the towing assembly for

damage or any unsafe condition before

attaching a load. If you are in doubt

about the safe operation of any of these

towing devices, DO NOT use them.

6. If you do not have experience towing

loads with your vehicle, WE STRONGLY

RECOMMEND that you read books or

get professional help before towing

any load. Grizzly will not be held liable

for accidents caused by lack of training

or failure to follow safe towing prac-

tices.

Specifications

 

 

 













 



 







 













Figure 1.















Summary of content (2 pages)

PAGE 1
MODEL G8731/G8732/ G8733 TOW DRAW BAR INSTRUCTIONS 1. This tow draw bar was designed to mount into a 2" x 2" square hitch receiver. NEVER use this product for any purpose it was not designed for. 2. Know your load and tongue weight! NEVER exceed the gross load towing capacity or the tongue weight capacity of the hitch receiver or draw bar. 3. 4. When mounting the draw bar, only use an approved hitch pin with a safety clip properly installed through the hitch receiver and draw bar.
PAGE 2
Installation 1. Make sure the 2" x 2" square hitch receiver and the tow draw bar are free from debris that could interfere with proper installation, and make sure that all devices used in towing are in good working condition. 2. Insert the shaft of the draw bar into the hitch receiver, install the 5⁄8" hitch pin (not included) through the hitch pin hole of both the receiver and draw bar, then secure it in place with the safety clip (see Figure 2).