Brush Cutter User Manual



Spindle Alignment
    
        
       

        


Horizontal Position Alignment
      
       

To use a test indicator to align the rotary
table:
1. 
2. 

       
Figure 4
 Note: Refer to Accessories on Page 15 for
test indicator options from Grizzly.
Figure 4.





3. 

 Note: For best results, turn the mill spindle in
only one direction.
4. 

5. 
Step 4
6.  Step 5     

 Tip: Use a mirror to read the indicator when
it is facing away from you.
To use an edge finder to align the rotary
table:
1.        
        


2.    ON     
      

3.         


 Note: When recording the mill table position,
take into account the backlash that is usually
present in the leadscrew.
4.        



5. 
Steps 34


