Drill User Manual

ManualsBrandsGrizzly ManualsDrillH8071



WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.



MODEL H8071

DRILL PRESS LATHE

ATTACHMENT

INSTRUCTIONS

Figure 1.

Specifications

 

 









 



Introduction

      











Figure 1

Inventory

     Figure 2   





    



       

 





Description Qty

A.  

B.  

C.  

D.  

E.  

F.  

G.  

H.  

I. 

J.  

K.  

Figure 2.



















 

Summary of content (4 pages)

PAGE 1
MODEL H8071 DRILL PRESS LATHE ATTACHMENT INSTRUCTIONS Introduction Inventory The Model H8071 Drill Press Lathe Attachment allows wooden workpieces to be turned on a drill press in the same manner as a wood lathe. Items like small pickets, legs, spindles, handles, dowels, and pins can be made. Fits drill press tables with T-nut slots or with slotted through holes as shown in Figure 1. Refer to the list and Figure 2 to inventory your package.
PAGE 2
Setup 7. If you need help with your new drill press lathe attachment, call our Tech Support at: (570) 5469663. Move the base so the tip of the live center is aligned with the spindle centerline, as shown in Figure 4. Next, tighten the base hex nuts. Tools Needed Qty Wrench 17mm.................................................... 1 To setup the drill press lathe attachment: 1. At each end of the workpiece, drill an 1⁄8" pilot hole 5⁄8" deep. 2. DISCONNECT POWER! 3.
PAGE 3
Operation Safety Read and follow these safety precautions: Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety glasses, a respirator, and hearing protection when operating this machine. EYE/FACE PROTECTION. Wear eye protection and a face shield during all turning operations. RESPIRATORY PROTECTION. Always wear a respirator when using this tool. Wood dust may cause allergies or long-term respiratory health problems.
PAGE 4
Operations Follow all safety precautions in your drill press Owner's Manual and these instructions. To use the drill press lathe attachment: 1. Put on safety glasses, a face shield, and tie back loose clothing and hair. 2. DISCONNECT POWER! DRILL PRESS FROM 3.