24" Planer/Sander Owner's Manual

<%+,,')EaVcZg$HVcYZg
"&."
Sanding Belt
To install the sanding belt:
1. L^i] i]ZbVX]^cZ XdccZXiZY id V^g! ijgc i]Z
WZaiiZch^dc`cdWidi]Z.dXadX`edh^i^dc#
2. GZbdkZi]Z adX`edhigZaZVhZ aZkZgFigure
18 Wn ijgc^c\ ^i XdjciZgXadX`l^hZ V
&
¿' ijgc
VcY ejaa^c\ ^i je VcY dji d[ i]Z bdjci^c\
]daZ#
3. GZbdkZi]ZheVXZgWadX`Figure 18#
4. BV`^c\hjgZi]ZgdiVi^dcVggdlhdci]ZhVcY"
^c\ WZai ed^ci i]Z hVbZ Y^gZXi^dc Vh i]dhZ
h]dlc^c Figure 18! ^chiVaai]Z hVcY^c\WZai
WnhiVgi^c\[^ghi dci]Z jeeZggdaaZgVcY i]Zc
i]ZadlZggdaaZg#
 Note: The sanding belt must be centered
between the limit switches, and the edge of
the sanding belt must be between the tongs
of the belt oscillation controller fork, as shown
in Figures 18 & 19. Damage to the sanding
belt and sander will occur if the sander is
turned ON before the sanding belt is correctly
positioned.
5. GZeaVXZ i]Z heVXZg WadX` VcY i^\]iZc Ydlc
i]ZadX`edhigZaZVhZaZkZg#
6. L^i] ndjg ]VcYh XaZVg d[ Vaa bdk^c\ eVgih!
ijgci]ZWZaiiZch^dc`cdWidi]Z&'/%%edh^"
i^dcidiZch^dci]ZWZai#
·>[i]ZWZaiiZch^dc`cdW^hijgcZYidi]Z./%%
edh^i^dc!i]ZWZail^aa]VkZcdiZch^dc#
NOTICE
The directional arrow on the back of the
sanding belt must be pointing in a coun-
terclockwise direction during installation.
Failure to install the sanding belt correctly
could result in damage to the sanding belt
or the sander itself.
Figure 19. HVcYZgdjia^cZidek^Zl#EgdeZg
edh^i^dcd[WZaiWZilZZci]Za^b^ihl^iX]Zh#
HVcY^c\7Zai
7VX`
;gdci
DhX^aaVi^dc8dcigdaaZg;dg`
A^b^iHl^iX]Zh
Figure 18. 8dbedcZcihjhZYl]ZcX]Vc\^c\V
hVcY^c\WZai#
HeVXZg
7adX`
GDI6I>DC
AdX`Edhi
GZaZVhZAZkZg
7Zai8ZciZgZY
>c;dg`
7ZaiIZch^dc
@cdW.D8adX`
Edh^i^dc