Manual



33. 

 Note: The rip fence body will scratch the
table surface if the ride height is not adjusted
correctly. Only the roller should touch the
table surface.
does not 

does 
       
      
Figure 44



34. 



35.         


Figure 44. 



Before proceeding with the next steps, wear
gloves to protect your hands when handling
and installing the blade.
Figure 43.
30.  


      
    
       
        
Figure 43
31.         

32. 
     

 Note: To adjust the mounting position of the
round rail, use the hex nuts (on the round rail
studs) that are on both sides of the tables.