Drill - Stationary Drill Press User Manual



6.        
ON
To remove tooling from the spindle:
1. 
2. 

3.        
    

Figure 14.


Tooling Changes
To install tooling in the spindle:
1. 
2. 


3. 


4. 

5.       
Figure 13

 Note:Overtightening the drawbar makes tool
removal difficult and stretches the threads of
the tool and drawbar.
NOTICE
DO NOT completely unscrew the drawbar
prior to striking the drawbar or the initial
threads of the drawbar and tool will be
crushed.
       
      


LACERATION HAZARD!
Leading edges of end mills
and other cutting tools can
be very sharp. Protect your
hands with gloves or a shop
towel when handling.
Figure 13.
4.        
 Figure 14      

5. 