Saw User Manual





6. 

7. 



8.       

       

      

        

Figure 31

Figure 30.















Figure 31.





4. 

5.      

       

       

Figure 30

Figure 32.



Note: For a quick gauge, fold a dollar bill in half

twice (four thicknesses of a dollar bill is approxi-

mately 0.016") and place it between the support

bearing and the blade as shown in Figure 32

9. 



10. Steps 49



NOTICE

Whenever changing a blade or adjusting ten-

sion and tracking, the upper and lower blade

support bearings and blade guide bearings

must be properly adjusted before cutting

operations.