Operation Manual

UK
120
Operation
Working safety
• Observethespeciedworkinganglein
order to guarantee safe working.
• Workvigilantlyandendangernobody
when sawing. Work calmly and conside-
rately.
• Ensureasafestancewithoutbeingham-
pered by branches, stones and trees. Do
not use the equipment when standing on
a ladder. Always keep the cutting gear in
view when working.
• Onaslope,alwaysstandaboveortothe
side of the branch to be sawn.
• Workonlyinadequatevisibilityandlight
conditions.
• Holdtheequipmentasclosetothebody
as possible. This gives you the best ba-
lance.
• Alwaysholdtheequipmentrmlywith
both hands.
• Carrytheequipmentbythetelescopic
handle with the cutting device pointing
backward. Attach the chain guard for
transporting the equipment (see
).
Sawing techniques
Be strictly aware of the risk from
rebound and from branches fal-
ling or lying on the ground.
• Sawing off small branches:
Apply the impact surface of the saw to
the branch in order to avoid sudden mo-
vements of the saw at the start of cutting.
Guide the saw downward through the
branch with slight pressure from above.
Be mindful of premature breaking of the
branch if you have misjudged the size
and weight.
Adjusting the telescopic handle
Thetelescopichandle(9)isinnitely
adjustable using the quick release (8)
1. Flap out the quick release (8) on
the telescopic handle (9).
2. Pull or push to adjust the length of
the telescopic handle (9).
3. Reclose the quick release (8).
Switching on and off
1. Form a loop at the end of the
extension cable and hang this in
the cable relief on the mains cable
(15).
2. Connect the equipment to the
mains.
 3. Holdthesawrmlywithboth
hands, with the right hand on the
operating handle and the left hand
on the round handle. Thumbs and
ngersmustbermlyaroundthe
handles (see picture
).
4. To switch on, operate the start lock
(12) then press the on/off switch
(13): the equipment runs at top
speed. Release the start lock.
5. The saw switches off when the on/
off switch is released.
A continuous operation setting is
not possible.