User manual



16. 
17.        


18.    
     l  ON 


19.        
  
     

20.        
     
Longitudinal Power Feed Page 26

Test Run
Spindle Break-In
Spindle Break-In
NOTICE
Successfully complete the spindle break-in
procedure to avoid rapid wear of spindle
components when placed into operation.
3. ON


4. 
    OFF     

5. 



6. OFF

       

7. 
Steps 4–5
8.    OFF    
       

     


       


    
SERVICE 
Page 43
Factory adjustments that should be verified:
1. Page 46
2. Page 47
Recommended
Adjustments



To perform the spindle break-in procedure:
1.     Test Run
OFF

2. 
    Selecting Spindle
Speed RangePage 30
