Operation Manual
28
GB
Only use the original charger from
the package to charge the battery.
Mind not to charge the appliance
for more than 9 hours at a time. If
you do, the battery and the appli-
ance may be damaged and longer
charging times would be a waste
of energy. Excessive charging will
void the warranty.
• Charge the battery before the rst
time of use. Do not briey charge the
battery several time in a row.
• Recharge the battery when you notice
that the appliance is becoming slower.
• If a fully recharged battery lasts for con-
siderably shorter operating times, the
battery is used up and needs to be re-
placed. Only use an OEM spare battery
available from our Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing / inserting the
battery
1. To remove the battery (9) from
the appliance, press the release
button (10) on the battery and
pull out the battery.
2. To insert the battery (9), place it
on the guide track (14) and push
it back into the appliance. It will
audibly snap in.
Recharging the battery
Allow a freshly charged battery to
cool down for approx. 15 minutes
before inserting it into the battery
charger).
1. Remove the battery (9) from the
appliance, as necessary.
2. Inser the battery (9) in the charging
compartment of the battery charger
(12). It will audibly snap in.
3. Plug the battery charger (12) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (12)
from the mains.
5. Press the release button ( 10)
on the battery (9) and pull the bat-
tery out of the battery charger (12).
Used batteries
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see “Waste Disposal and
Environmental Protection”).
Operating
Wear suitable clothing and work
gloves when working with the
equipment.
Ensure that the equipment is
functional before each use. The
On/O switch and the safety
switch must not be held closed.
They must switch o the motor
when on is released. Should a
switch be damaged, stop work-
ing with the equipment. Ensure
that the mains voltage value
matches the label on the equip-
ment.