Operation Manual

GB
73
Risk of electric shock.
• Disconnect the charger from the
mains before closing or opening
connection to the battery / power
tool / device.
• Keep the charger clean and away
from wet and rain. Do not use the
charger outdoors. Dirt and the entry
of water increase the risk of electric
shock.
• Operate the charger only with the
appropriate original batteries.
Charging other batteries may result in
injuries and risk of re.
• Avoid mechanical damage to the
charger. This can result in internal
short circuits.
• Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of re due to heating
during charging.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
ed person in order to prevent haz-
ards.
• Do not use the charger to charge non-
rechargeable batteries.
6) RESIDUAL RISKS
Even if this power tool is operated in ac-
cordance with the instructions, some re-
sidual risks always remain. The following
hazards may occur in connection with the
construction and design of this power tool:
a) Cuts
b) Hearing damage if no suitable hearing
protection is worn.
c) Damage to health as a result of hand-
arm vibrations if the equipment is
used over a prolonged period or not
properly operated and maintained.
Warning! This power tool gener-
ates an electromagnetic eld dur-
ing operation. Under certain condi-
tions, this eld may impair active
or passive medical implants. To
reduce the risk of serious or fatal
injuries, we recommend that peo-
ple with medical implants consult
their doctors and the manufacturer
of the medical implant before oper-
ating the machine.
General description
The illustration how to handle the
appliance can be found on the
pages 2-3.
Function description
The battery-powered grass and bush trim-
mer is a combination unit with two inter-
changeable cutting devices. These are
coated with plastic to prevent rust. For
use as a shrub trimmer, a double-sided
blade block is used as the cutting head.
When cutting, the blades oscillate linearly
against an unsharpened cutting plate. The
catching blades are round off at the side
to prevent accidents, and positioned in an
offset arrangement to reduce the risk of
injury. A cutting head with several blades is
provided for use as a grass trimmer. This
also oscillates on a bladed plate, producing
the same movement as a pair of scissors.
The unit is equipped with a telescopic shaft
and rollers for increased working speed
and comfort. Please read the following
descriptions for the function of the various
controlling parts of the unit.