Instruction Manual
Note:If the front end of the fence needs to
be adjusted up or down, use the set screws
from Figure 136; however, turn them in
even increments and recheck the square-
ness afterwards.
Clamping Pressure and Parallelism
Figure 138.
Fence is
Parallel to
Miter Slot,
which is
Parallel to
Blade
Miter Slot
Blade
Fence
To verify fence parallelism:
1.
Figure 137 Page 70
2.
Figure
138
Figure 138
Miter Slot to Blade Parallelism
Page 66
To adjust the fence clamping pressure and
parallelism to the blade:
1.
2.
Figure 139
Figure 139.
Set Screws
Fence Bracket
3.
4.