Instruction Manual

 
Workpiece
Fence
Blade
Figure 85. 
6. 

7. 
Figure 85
       

Fence
Blade
Workpiece
Figure 84. 

    

Page 33


To cut rabbets with the standard blade:
1. 
2.       

3. 



4. 

5.        
Figure 84, 


Cutting Rabbets with a Standard
Blade
 



DO NOT place a tall board on edge to per-
form a rabbet cut with a standard blade.
Workpieces that are too tall to properly sup-
port with the fence can easily shift during
operation and cause kickback. Instead, place
the stock flat on the saw and perform the
rabbet cut with a dado blade, as instructed
on Page 45.
15
30
45