Instruction Manual

 
Figure 58. 
Laminate blade features:
• Best for cutting plywood or veneer
• 40-80 teeth
• Triple chip tooth profile
• Very shallow gullet
Triple
Chip
Blade
Figure 59. 
Dado Blades
Stacked Dado Blade (see below): Multiple
blades are stacked together to control the cutting
width. Stacked dado blades are more expensive
than wobble blades, but typically produce higher
quality results.
Wobble Dado Blade: A single blade mounted at
a slight angle on an arbor hub. The blade angle is
adjustable on the hub, and the width of the dado
cut is controlled by the angle setting of the blade.
Thin Kerf Blade: A blade with thinner kerf than
a standard blade. Since the spreader/riving knife
included with this table saw is sized for standard
blades, thin kerf blades cannot be used on this
saw unless they meet the Blade Requirements
specified in this manual; otherwise, they will
increase the risk of kickback.
5. 


Figure 60
6. 

Figure 61.

Figure 60.
To install a new blade:
1. 
2. 

3. 
      Note: The
arbor nut has right hand threads; turn it coun-
terclockwise to loosen.
Blade Installation
4.  
        
Figure 61.