Instructions

61
GB
internal short circuits.
• Do not operate the charger on
or in the immediate vicinity
of ammable surfaces (e.g.
paper, textiles). There is a risk
of re due to the heat generated
during the charging process.
• If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same or
a similarly qualied person
in order to prevent hazards.
• Do not use the charger to
charge non-rechargeable bat-
teries.
Charging process
Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Charge the battery only in dry
areas.
Do not switch on the device
while charging it.
There is a risk of injury from
electric shock.
1. The safety key (8) must be du-
ring the loading process plug.
2. Connect the charger cable plug
(18) with the charger socket on
the tool (7).
3. Connect the power supply unit
(17) to a socket.
The charging indicator (3) lights
up:
Red: Equipment charging.
Green: Charging nished.
The recommended charging
time is 1 hour. This charging
time is only achieved using the
power supply.
4. After the recharging process
is completed, rst unplug the
charger from the wall outlet, and
then remove the charger cable
plug (18) from the tool.
Operation
Keep to noise abatement regula-
tions and other by-laws.
Switching on and off
1. Remove the blade guard
(12/15) before switching the unit
on.
2. Insert the safety key (8) into the
device.
3. To switch on, hold the switch
lock (4) depressed and operate
the on/o󰀨 switch (9). Then re-
lease the switch lock.
The equipment runs at top
speed.
4. In order to switch o󰀨, let go of
the on/o󰀨 switch (9).
After switching the unit o󰀨, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the moving blades and
do not try to stop them moving.
Injury hazard!