Use and Care Manual

-26-
Model T28780 T28781 (Mfd. Since 04/20)
To connect router and router table to power:
1. Ensure router table paddle switch is set to OFF
position.
2. Loosen (2) 10-24 x
3
⁄8" Phillips head screws
securing side door on dust box, and feed
router power cord through opening.
3. Plug router power cord into 110V receptacle
on router table electrical box.
4. Plug router table power cord into matching
power supply outlet.
5. Install
1
⁄2" strain relief (see Figure 39) on
router power cord where it emerges from the
dust box side panel and secure by retighten-
ing screws.
Leveling
Router Table
The feet on the Model T28780/T28781 are adjust-
able and used to level the router table. This keeps
it from rocking during routing operations.
To level router table:
1. Place router table on a flat, clean surface.
2. Loosen (4)
1
⁄2 "-12 hex nuts (see Figure 38)
on router table feet.
Connecting
Power Cords
To reduce risk of injury from accidental
contact with spinning router bit, ALWAYS
make sure router table is placed on a flat,
clean surface and then leveled before router
operations.
The Model T28780/T28781 includes an electri-
cal box with a 110V receptacle and an ON/OFF
paddle switch (see Figure 39). The router power
cord can be plugged directly into the electrical
box, and the power cord on the electrical box can
be plugged into a 110V outlet. This allows you to
start and stop your router without having to reach
into the dust box for the router ON/OFF switch.
Figure 39. Location of ON/OFF switch and 110V
receptacle.
ON/OFF
Switch
110V Receptacle
Strain
Relief
Figure 38. Foot components.
Hex Nut
Foot
3. Adjust router table feet to ensure table is
stable and does not rock.
4. Tighten hex nuts to secure router table feet.