Use and Care Manual

Model T28780 T28781 (Mfd. Since 04/20)
-23-
21. Install (1)
1
⁄4" -20 x
3
⁄4" carriage bolt in top slot
of infeed/outfeed fence face (see Figure 27).
23. Attach ON/OFF switch (see Figure 29) to
front, righthand leg of stand with pre-installed
clamp and (2)
1
⁄4" -20 x 1
1
⁄2" hex bolts and (2)
1
⁄4" flat washers.
Figure 29. Attaching ON/OFF switch to front of
stand.
Figure 30. Attaching dust box to table.
20. Press (4) fence end caps into position, as
shown in Figure 26.
22. Attach router bit guard (see Figure 28) to
carriage bolts in fence with (2)
1
⁄4 "-20 plastic
knobs.
24. Install dust box (see Figure 30) underneath
table with (4) 10-24 x
3
⁄8" Phillips head screws.
Note: The vent should be facing the front of
the machine.
Figure 27. Carriage bolts installed on fence.
Carriage Bolts
Infeed Fence
Outfeed Fence
x 2
Figure 28. Router bit guard secured to fence
with plastic knobs.
Knob
Guard
Knob
25. Install Y-fitting (see Figure 31) on dust port
and secure with (1)
1
⁄4" -20 x
1
⁄2" knob bolt.
Figure 31. Y-fitting attached to dust port.
Y-Fitting
Knob Bolt
Figure 26. End caps pressed into fences.
End Caps
(2 of 4)