Use and Care Manual

-22-
Model T28780 T28781 (Mfd. Since 04/20)
15. Secure infeed fence to base with (4)
1
⁄4" flat
washers and (4)
1
⁄4 "-20 steel knobs (see
Figure 23).
13. Install (2)
1
⁄4"-20 x
3
⁄4" carriage bolts in the
center slot of infeed fence (see Figure 21).
14. Align carriage bolts with vertical slots in fence
base and install infeed fence (see Figure 22).
16. Repeat Steps 13-15 to install outfeed fence
on opposite side of base.
17. Align (2) holes in fence base with slots in
table. Insert (2)
5
⁄16" -18 T-bolts (see Figure
24) through table and fence base, as shown
below.
Note: Ensure T-bolts sit flush in T-slots
underneath the table.
18. Assemble (2) fence locks (see Figure 25)
by removing one ball knob on each handle,
sliding it through hole at top of shaft, then re-
installing knob.
19. Install (1)
5
⁄16" flat washer and (1) fence lock
(see Figure 25) on each T-bolt installed in
Step 17.
Figure 21. Carriage bolts installed in infeed
fence.
Carriage Bolts
Infeed Fence
x 2
Figure 25. Fence locks installed.
Handle
Shaft
Ball
Knob
Washer
Figure 24. T-bolts inserted through table and
fence base.
T-Bolt
Fence
Base
x 2
Figure 22. Infeed fence installed on fence base.
Infeed Fence
Fence Base
Vertical Slots
Carriage Bolts
Figure 23. Infeed fence secured to base.
Fence
Knobs & Flat Washers
(2 of 4)