Use and Care Manual

Model T28780 T28781 (Mfd. Since 04/20)
-21-
7. T28781 Only: Attach right and left extension
wings (see Figure 17) to router table with (6)
3
⁄8 "-16 x 1
1
⁄2" cap screws, (6)
3
⁄8" flat washers,
and (6)
3
⁄8" -16 lock nuts.
Note: Place level or straightedge across rout-
er table and each extension wing to ensure
they are flush side to side and front to back
and that the T-slots align squarely.
8. Position router lift assembly inside table
opening (see Figure 18) so mounting plate is
flush with table top.
9. Lay straightedge across mounting plate, plate
insert, and table surfaces in pattern shown in
Figure 19.
Straightedge
Mounting
Plate
Table Surface
Figure 19. Pattern for aligning mounting plate.
10. Adjust set screws (see Figure 18)
so that ends of straightedge lay flat on
table surface at all positions of pattern
above.
IMPORTANT: Mounting plate and table
surface must be aligned evenly to ensure
workpiece does not catch on mounting plate
or table surface and kick back.
11. Once mounting plate is even with table sur-
face, secure position with (2) M4-.7 x 16 cap
screws shown in Figure 18.
12. Attach dust shroud (see Figure 20) to back
of fence base with (2)
1
⁄4"-20 x
5
⁄8" flat head
screws, (2)
1
⁄4" flat washers, and (2)
1
⁄4"-20
hex nuts.
Figure 17. Extension wings installed.
x 6
Figure 18. Router lift assembly positioned inside
table opening.
Cap
Screws
Set Screws
(1 of 8)
Figure 20. Dust shroud attached to fence base.
Dust
Shroud
Fence Base
x 2