Use and Care Manual

-8-
Model T1244 (Mfd. Since 10/17)
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 1) Qty
A. Dust Port 2
1
⁄2" ............................................. 1
B. Dust Port Adapter 2
1
⁄2"–2
1
⁄4" ....................... 1
C.
Router Table Extension Wing w/Miter Slot . 1
D.
Router Bit Guard ........................................ 1
E.
Fence Bracket ............................................ 1
F.
Router Mounting Plate ................................ 1
G.
Fences (Infeed and Outfeed) ..................... 2
H.
Fence Scales (0"–15
11
⁄16") ........................... 2
Hardware Bag (Figure 2)
I.
Table Insert (Solid) ..................................... 1
J.
Knobs 8-Lobe ............................................. 6
K.
Table Insert (32mm ID) ............................... 1
L.
Table Insert (37mm ID) ............................... 1
M.
Knobs 3-Lobe ............................................. 2
N.
Fender Washers 6mm ................................ 2
O.
T-Bolts ........................................................ 2
P.
Square Washers 10mm .............................. 4
Q.
Hex Nuts M6-1 ........................................... 2
R.
J-Hooks ...................................................... 2
S.
Phillips Head Screws M5-.8 x 55 ............... 2
T.
Flat Head Screws M4-.7 x 5 ....................... 3
U.
Flat Head Screws M6-1 x 16 ...................... 3
V.
Hex Bolts M8-1.25 x 25 .............................. 6
W.
Flat Washers 8mm ..................................... 6
X.
Set Screws M6-1 x 6 .................................. 4
Y.
Starting Pin ................................................. 1
Z. Hex Wrench 3mm ....................................... 1
AA.
Hex Bolts M10-1.5 x 40 .............................. 6
AB.
Hex Bolts M8-1.25 x 40 .............................. 4
AC.
Flat Washers 10mm ................................... 8
AD.
Lock Washers 8mm.................................... 4
AE.
Hex Nuts M8-1.25 ....................................... 4
Figure 1. T1244 inventory.
A
B
C
D
E
F
G
H
Figure 2. Hardware bag inventory.
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
X Y
Z
AB
W
AC
AD
AE
AA