Use and Care Manual

-24-
Model G1014Z/G1014ZX (Mfd. Since 07/17)
12. Loosen the two set screws on the work table
arm so their ends are flush with the inside of
the opening, as shown in Figure 31.
Figure 31. Location of set screws on work table
arm.
13. Loosen the angle adjustment knob on the
work table (see Figure 31), tilt the table to the
0º mark, then tighten the knob.
14. Slide the work table arm onto the table sup-
port rod, making sure that the set screws on
the table arm face the flat part of the rod, as
shown in Figure 32.
Figure 32. Installing work table onto table
support rod.
15. Using a ruler adjust the edge of the work
table approximately
1
⁄16" away from the sand-
ing disc on both sides (see Figure 33), then
tighten the set screws on the work table arm.
—If the gap between the work table and the
sanding disc is not the same on both sides,
loosen one of the table mount bracket
screws (see Figure 31), adjust the table
as needed to even the gap, then tighten
the screw.
Figure 33. Correct distance between disc and
work table.
1
⁄16"
Gap
16. Square the table to the sanding disc (refer to
instructions on Page 48 for more details).
17. Adjust the miter gauge slot parallel with the
sanding disc (refer to instructions on Page
49 for more details), then insert the miter
gauge.
Work
Table
Arm
Table Mount
Bracket Screw
Set
Screws
Angle
Adjustment
Knob
Opening
To reduce the risk of your fingers getting
stuck between the work table and sanding
disc, set the table approximately
1
⁄16" away
from the sanding disc.